A Gilbert cell multiplier is a type of analog multiplier used in RF (Radio Frequency) circuits to perform signal multiplication. It is commonly employed in RF mixers, modulators, demodulators, and other RF signal processing applications. The Gilbert cell is a key component in the classic Gilbert cell mixer, which is widely used in RF and communication systems.
The Gilbert cell multiplier utilizes the differential pair configuration to achieve signal multiplication. Here's a step-by-step explanation of how it works:
Differential pair: The core of the Gilbert cell is a differential pair of transistors, typically implemented using bipolar junction transistors (BJTs) or more commonly, complementary metal-oxide-semiconductor (CMOS) transistors. This differential pair is composed of two transistors with their emitters or sources tied together and the collectors or drains connected to the input signals.
Biasing: Proper DC biasing is applied to the differential pair to keep it in its linear operating region. Biasing ensures that the transistors operate within the range where their small-signal behavior is approximately linear, allowing for accurate signal multiplication.
Input signals: The Gilbert cell has two input ports, typically labeled as RF and LO (Radio Frequency and Local Oscillator, respectively). The RF signal is the input signal that needs to be multiplied, while the LO signal is provided by a local oscillator and acts as the controlling signal.
Non-linear switching: When the LO signal changes state (from low to high or vice versa), it controls the switching behavior of the transistors in the differential pair. This switching action creates two phases in the differential pair's operation.
Phase action: The Gilbert cell operates in two phases. In the first phase, the LO signal is at a low level, and one transistor of the differential pair is in the active region, while the other is in the cutoff region. In the second phase, the LO signal goes to a high level, and the roles of the transistors are reversed.
Output generation: As the differential pair switches between phases, the multiplication of the RF and LO signals takes place. The differential output voltage of the Gilbert cell contains both sum and difference frequencies, but it is usually filtered to obtain only the desired frequency components.
By controlling the LO signal, the Gilbert cell effectively multiplies the RF input signal by the LO signal, producing an output that contains the sum and difference of the two frequencies. By filtering the output, the desired multiplication result can be extracted for further processing in RF circuits. The ability of the Gilbert cell multiplier to perform signal multiplication with good linearity and efficiency makes it an essential building block in many RF communication systems.