A relay driver is a circuit or device designed to activate an electromechanical relay using a low-power signal. Electromechanical relays are switches that use an electromagnet to mechanically close or open electrical contacts. They are commonly used in applications where a low-power electronic signal needs to control a higher-power electrical circuit.
Here's a general explanation of how a relay driver works to activate an electromechanical relay:
Electromechanical Relay Basics: An electromechanical relay consists of a coil (electromagnet) and one or more sets of contacts. When a current flows through the coil, it generates a magnetic field, which causes the contacts to move and either make or break an electrical connection.
Low-Power Signal Input: The relay driver receives a low-power signal as its input, typically from a microcontroller, logic circuit, or other low-power electronic devices. This signal is often at a lower voltage and current level, insufficient to directly activate the relay.
Amplification and Isolation: The primary function of the relay driver is to amplify the low-power signal to a level sufficient to energize the relay coil. Additionally, the driver may provide isolation between the low-power control circuit and the higher-power relay circuit to protect sensitive electronics from potential voltage spikes or interference.
Transistor Amplification: One common approach in relay drivers is using transistors, such as bipolar junction transistors (BJTs) or field-effect transistors (FETs). Transistors can act as electronic switches that can be controlled by a small input current to allow a larger current (from a separate power supply) to flow through the relay coil.
For example, with an NPN BJT, a small current flowing into the base terminal can allow a larger current to flow from the collector to the emitter. This larger current can then be used to energize the relay coil.
A similar principle applies to FETs, where a small voltage applied to the gate terminal can control a larger current flowing between the drain and source terminals.
Protection Diodes: When driving an inductive load like a relay coil, it is crucial to include protection diodes across the relay coil. These diodes (known as flyback diodes or freewheeling diodes) help suppress voltage spikes that occur when the current flowing through the relay coil is suddenly interrupted (e.g., when the relay turns off). The protection diodes ensure that the voltage spike is safely redirected and not propagated back to the driver circuit.
Power Supply for the Relay: The relay driver may also include a separate power supply for the relay coil, especially if the relay requires a higher voltage or current than what the low-power signal can provide.
By using a relay driver, you can efficiently control electromechanical relays using low-power electronic circuits, making them suitable for a wide range of applications, including automation, motor control, home appliances, and industrial systems.