A peak detector is an electronic circuit that captures and holds the highest voltage level (peak voltage) of an input signal. It is commonly used in various applications such as audio and video processing, data acquisition, and signal conditioning.
The basic concept behind a peak detector is to "detect" the highest voltage level of the input signal and "hold" that voltage until it is reset or a new peak is detected. The process of capturing and holding the peak voltage can be achieved using simple components such as diodes, capacitors, and resistors. Here's a general explanation of how a peak detector works:
Diode: The core component of the peak detector is a diode. A diode allows current to flow in one direction only. In this case, it is connected in such a way that it allows the capacitor to charge (but not discharge) when the input voltage is higher than the voltage across the capacitor.
Capacitor: The capacitor is used to store and hold the voltage level when the input signal reaches its peak. When the input signal's voltage is higher than the voltage across the capacitor, the capacitor starts charging.
Resistor: A resistor is usually connected in parallel with the capacitor to provide a discharge path. This resistor helps in slowly discharging the capacitor when the input signal decreases or when the peak voltage needs to be reset.
Working principle:
Capture (Charge): When the input signal increases and reaches its highest voltage level (peak), the diode becomes forward-biased, allowing current to flow through it. This causes the capacitor to charge up to the peak voltage level. The capacitor will charge quickly to the peak voltage level due to the low impedance path provided by the diode.
Hold: Once the capacitor charges to the peak voltage, it acts as a storage element, holding the peak voltage level even if the input signal starts to decrease.
Release (Reset): To reset the peak detector, a separate mechanism can be used. For example, a switch can be included that allows the capacitor to discharge through the parallel resistor, effectively resetting the capacitor's voltage level to zero.
It's important to note that the capacitor may slowly discharge over time due to leakage current, and this can affect the accuracy and reliability of the peak detector. The choice of components and their values can impact the speed of the peak detection and the rate of discharge.
Peak detectors are simple but useful circuits, and variations of them are commonly used in various electronic systems where capturing and holding peak voltages is required for further processing or analysis.